General Contractor in Revere, MA
Carpentry comes before coating on Revere exteriors. Salt attacks nails and screws as well as coatings. Exterior carpentry here needs the right fasteners or the repair fails before the paint does. We repair or replace it first, because paint over soft wood buys a season.
General Contractor Services in Revere
Carpentry Repair in Revere
Trim, doors, porches and structural wood — We repair the wood before we paint it. Painting over a rotted board is a one-season fix.. If you want the detail, here's how we handle carpentry repair in Revere.
Wood Rot Repair in Revere
Fascia, sills, casings and corner boards — Cut out the rot, treat with epoxy consolidant where the piece is salvageable, replace it where it isn't.. If you want the detail, here's how we handle wood rot repair in Revere.
Siding Repair in Revere
Clapboard, shingle and fiber cement — Damaged courses replaced and profile-matched, then primed on all sides before they go up.. If you want the detail, here's how we handle siding repair in Revere.
Trim Installation in Revere
Baseboard, casing, crown and millwork — Installed, caulked and painted as one job so the finish lines up with the walls.. If you want the detail, here's how we handle trim installation in Revere.
More from us around Revere: Start from the Revere overview.
More on this trade generally: General Contracting across our service area.
Small Crew, Licensed, Fully Covered
Aura is family-run out of Allston. Licence #193121 is on file with the Commonwealth, and both liability and workers' comp are in force on every property we set foot on.
Estimates in Revere
Estimates are written, itemised, and free.
(617) 777-7700 Call Now Request OnlineWhat General Contracting Work Here Actually Involves
Two- and three-families through the centre, beachfront and near-beach houses and condos along the shore, and postwar single-families inland.
Most of our general contracting work here is for beach-side homeowners and condo associations dealing with accelerated weathering, plus inland multi-family owners.
Direct ocean exposure
Point of Pines, Beachmont and the Revere Beach frontage take salt spray and wind-driven rain directly. Coating life is measurably shorter than a mile inland.
Fastener corrosion
Salt attacks nails and screws as well as coatings. Exterior carpentry here needs the right fasteners or the repair fails before the paint does.
Wind-driven rain
Exposed elevations take rain sideways. Caulk joints and end grain fail first and need checking every cycle.
What a Contracting Quote Has to Account For
What drives the price
Carpentry pricing is mostly about what is behind the surface, which nobody knows until it is open. We price the known scope firmly and carry the unknowns as a written allowance rather than a vague contingency, so a rot repair that turns out to run further than the visible damage does not become an argument halfway through. In Revere specifically, the work is mostly beach-side multi-family and two-families, and maximum salt and wind exposure shapes how we schedule and stage it.
How the work is sequenced
Repairs come before finishes, always. There is no point painting trim that is going to be replaced, and no point replacing trim while the flashing above it is still letting water in. We work from the water source down: flashing and drainage first, then the substrate, then the carpentry, then the coating.
Where it usually goes wrong
The common failure is cosmetic work done over an unresolved cause. Filler over rot that still has a moisture path behind it will fail again in a season, and the second repair costs more than the first because the damage has spread. If we find a source we cannot fix, we tell you before we coat over it rather than after.
How long it takes
Carpentry runs on material availability as much as labour. Stock trim and standard dimensional lumber are immediate. Matched profiles for older houses can take weeks to source or mill, and we flag that at the estimate rather than discovering it mid-job.
Recent Work
Before & After
Drag the handle to compare
Colonial exterior, full repaintClapboard had failed down to bare wood across the elevation. Washed, scraped back, feathered, wood repaired, primed and finished in two coats.
Questions We Get Asked
Do you fix the wood before painting it in Revere?
Can you match old trim profiles?
Is carpentry quoted separately?
Ready for Your General Contractor Estimate in Revere?
We walk the property, measure it, and send a written itemised quote — normally inside 24 hours. No pressure, no obligation.
Licensed #193121 · Fully insured · 2-year workmanship warranty